1 files changed, 1 insertions, 1 deletions

diff --git a/fanduct.scad b/fanduct.scad
index 975f1cc..53630a3 100644
--- a/fanduct.scad
+++ b/fanduct.scad
@@ -12,33 +12,33 @@ heater_clearance = max(
 );
 
         fanduct_elevation = 3;                                          // fanduct elevation above nozzle tip
         fanduct_blowtarget = -2;                                        // what to blow at
         fanduct_h = 6;                                                  // inner height of the duct
         fanduct_w = 7;                                                  // inner width of the duct
         fanduct_shell=1.2;                                              // shell thickness
         fanduct_ir = heater_clearance+5;                                // inner radius
 
         jet_angle = 60-2;       // angular width of the jet
 
         inlet_w = 12.5;         // inlet width
         inlet_h = 17;   // inlet height
         inlet_l = 7;    // inlet length of protrusion (or depth of intrusion:))
         inlet_away = 15;// how far away inlet is
 
-hotend_clearance = 12;
+hotend_clearance = heater_clearance;
 
         snapper_d = 8; snapper_overlap=0.2;// snip snap
 
 smooth_f = 120;
 
 type="3jets"; // "3jets" ; // circular|3jets
 
 
 module fanduct(type=type) {
 
          //     ***duct is all around!
  module duct(what) {
   if(what=="in") {
    sh = fanduct_w+2*fanduct_shell; sv = fanduct_h+2*fanduct_shell;
    smax = max(sh,sv);
    rotate_extrude($fn=smooth_f)