make the blow target adjustable

blow a bit below layer printed to target the neighborhood instead of
the very nozzle

1 files changed, 5 insertions, 4 deletions

diff --git a/fanduct.scad b/fanduct.scad
index 7fc1ff4..f4bb705 100644
--- a/fanduct.scad
+++ b/fanduct.scad
@@ -10,2 +10,3 @@ nozzle_offset=4.5;	// nozzle offset from the edge of heatblock
         fanduct_elevation = 3;                                          // fanduct elevation above nozzle tip
+        fanduct_blowtarget = -2;                                        // what to blow at
         fanduct_h = 6;                                                  // inner height of the duct
@@ -83,6 +84,6 @@ module fanduct(type=type) {
       polygon([
-       [0,-fanduct_elevation],
+       [0,-fanduct_elevation+fanduct_blowtarget+epsilon],
        [fanduct_ir+fanduct_shell,fanduct_shell+fanduct_h/2],
        [fanduct_ir+fanduct_shell+fanduct_w/2,0],
-       [0,-fanduct_elevation-.1]]);
+       [0,-fanduct_elevation+fanduct_blowtarget-epsilon]]);
      translate([0,0,-1])
@@ -96,6 +97,6 @@ module fanduct(type=type) {
     polygon([
-     [0,-fanduct_elevation],
+     [0,-fanduct_elevation+fanduct_blowtarget+epsilon],
      [fanduct_ir+fanduct_shell+1,fanduct_h/2],
      [fanduct_ir+fanduct_w/2+fanduct_shell+1,fanduct_shell],
-     [0,-fanduct_elevation-.1]]);
+     [0,-fanduct_elevation+fanduct_blowtarget-epsilon]]);
    }else if(what=="airguides") {