| -rw-r--r-- | noncore/net/wellenreiter/README | 17 |
1 files changed, 15 insertions, 2 deletions
diff --git a/noncore/net/wellenreiter/README b/noncore/net/wellenreiter/README index af2e611..ada9321 100644 --- a/noncore/net/wellenreiter/README +++ b/noncore/net/wellenreiter/README @@ -10,51 +10,64 @@ Release Notes for Opie-ALPHA Version January 2002 -------------------------------------------------- ===================== = Supported Devices = ===================== * low-level orinoco_cs-based (including prism2 and spectrum_cs) ===================== = Build = ===================== +(I) Opie Build Environment + To compile Wellenreiter within the Opie build environment, add the following directories to $OPIEDIR/Makefile, e.g. to 'NONAPPS=' noncore/net/wellenreiter/libwellenreiter \ noncore/net/wellenreiter/daemon \ noncore/net/wellenreiter/contrib/orinoco_hopper \ noncore/net/wellenreiter/gui ./configure and rebuild. Note that you need libpcap in your toolchain. +(II) OpenZaurus Build Environment + To compile Wellenreiter within the OZ build environment, add the -following lines to $OPIEDIR/packages +following lines to $OPIEDIR/packages: CONFIG_WELLENREITER noncore/net/wellenreiter/libwellenreiter libwellenreiter.pro CONFIG_WELLENREITER noncore/net/wellenreiter/daemon daemon.pro CONFIG_WELLENREITER noncore/net/wellenreiter/gui gui.pro CONFIG_WELLENREITER noncore/net/wellenreiter/contrib/orinoco_hopper orinoco_hopper.pro make -f Makefile.test clean-configs cd <BUILDROOT> make SUBDIRS=packages/opie package +(III) To compile a standalone Wellenreiter for X11, you need Qt3 and the development +packages for Qt3, e.g. libqt3-devel. Assuming, $OPIEDIR and $QTDIR is set to Opie resp. +Qt (e.g. /usr/lib/qt3), do the following: +export QMAKESPEC=$OPIEDIR/mkspecs/linux-g++ +cd $OPIEDIR/noncore/net/wellenreiter +qmake -makefile wellenreiter.pro +make qmake +make + ===================== = Install = ===================== Alternatively, you can use our precompiled ipk. Get it from -http://opie.net.wox.org/wellenreiter/current/. This also includes a recent libpcap. +http://opie.net.wox.org/wellenreiter/. This also includes a recent libpcap. ===================== = Run = ===================== There are two possible modes: <Manual> and <Automatic>. I suggest, you start with the <Automatic> Mode. This works just using the "Start" and "Stop" Pushbuttons in the Wellenreiter GUI. If this doesn't work, then use the following strategy: 1. Place card in monitor mode. This is device dependent. |