1 files changed, 19 insertions, 0 deletions

diff --git a/i18n/zh_TW/light-and-power.ts b/i18n/zh_TW/light-and-power.ts
index 4e6f4be..b409b6d 100644
--- a/i18n/zh_TW/light-and-power.ts
+++ b/i18n/zh_TW/light-and-power.ts
@@ -1,57 +1,64 @@
 <!DOCTYPE TS><TS>
 <context>
     <name>Calibration</name>
     <message>
         <source>%1 Steps</source>
         <translation>%1 階</translation>
     </message>
 </context>
 <context>
+    <name>LightSettings</name>
+    <message>
+        <source>Backlight &amp;&amp; Contrast</source>
+        <translation type="unfinished"></translation>
+    </message>
+</context>
+<context>
     <name>LightSettingsBase</name>
     <message>
         <source>By sensing the ambient light where you are using your device, the screen light can be adjusted automatically. The brightness setting still affects the average brightness.</source>
         <translation>讓您的裝置發出背光, 螢幕背光是可以自動調整的. 亮度 設定值仍會影響平均的亮度.</translation>
     </message>
     <message>
         <source>Dim light after</source>
         <translation>在此時間後調暗背光</translation>
     </message>
     <message>
         <source>Suspend after</source>
         <translation>在此時間後暫停</translation>
     </message>
     <message>
         <source>Light off after</source>
         <translation>在此時間後關閉背光</translation>
     </message>
     <message>
         <source>Off</source>
         <translation>關</translation>
     </message>
     <message>
         <source>Light and Power Settings</source>
         <translation>背光與電源設定</translation>
     </message>
     <message>
         <source>on Battery</source>
         <translation>使用電池</translation>
     </message>
     <message>
         <source>General Settings</source>
         <translation>一般設定</translation>
     </message>
     <message>
         <source> sec</source>
         <translation> 秒</translation>
     </message>
     <message>
         <source>never</source>
         <translation>永不</translation>
     </message>
     <message>
         <source>Deactivate LCD only (does not suspend)</source>
         <translation>只關閉 LCD (不使用暫停)</translation>
     </message>
     <message>
         <source>Backlight</source>
         <translation>背光</translation>
@@ -67,85 +74,97 @@
     <message>
         <source>Use Light Sensor</source>
         <translation>使用光線偵測器</translation>
     </message>
     <message>
         <source>Calibrate</source>
         <translation>校正</translation>
     </message>
     <message>
         <source>Advanced settings for light sensor handling</source>
         <translation>光線偵測器處理的進階設定</translation>
     </message>
     <message>
         <source>on AC</source>
         <translation>使用外部電源</translation>
     </message>
     <message>
         <source>Warnings</source>
         <translation>警告</translation>
     </message>
     <message>
         <source>Low power warning interval</source>
         <translation>低電量警告間隔</translation>
     </message>
     <message>
         <source> %</source>
         <translation> %</translation>
     </message>
     <message>
         <source>At what battery level should the low power warning pop up</source>
         <translation>電池電量低到什麼程度時要彈出低電量警告</translation>
     </message>
     <message>
         <source>how often should be checked for low power. This determines the rate popups occure in low power situations</source>
         <translation>檢查低電量的頻率. 這也決定了在低電量情形下彈出警告的頻率</translation>
     </message>
     <message>
         <source>At what battery level should the critical power warning pop up</source>
         <translation>電池電量低到什麼程度時要彈出極低電量警告</translation>
     </message>
     <message>
         <source>very low battery warning at</source>
         <translation>非常低電量警告於</translation>
     </message>
     <message>
         <source>critical power warning at</source>
         <translation>極低電量警告於</translation>
     </message>
+    <message>
+        <source>CPU Frequency</source>
+        <translation type="unfinished"></translation>
+    </message>
+    <message>
+        <source>set a fix value for contrast</source>
+        <translation type="unfinished"></translation>
+    </message>
+    <message>
+        <source>CPU frequency</source>
+        <translation type="unfinished"></translation>
+    </message>
 </context>
 <context>
     <name>SensorBase</name>
     <message>
         <source>Sensor Calibration</source>
         <translation>偵測器校正</translation>
     </message>
     <message>
         <source>Full</source>
         <translation>全滿</translation>
     </message>
     <message>
         <source>Off</source>
         <translation>關閉</translation>
     </message>
     <message>
         <source>Dark</source>
         <translation>黑</translation>
     </message>
     <message>
         <source>Light</source>
         <translation>亮</translation>
     </message>
     <message>
         <source>Steps</source>
         <translation>階級</translation>
     </message>
     <message>
         <source>Check interval</source>
         <translation>檢查間隔</translation>
     </message>
     <message>
         <source> sec</source>
         <translation> 秒</translation>
     </message>
 </context>
 </TS>