Diffstat (limited to 'noncore/net/wellenreiter/README') (more/less context) (ignore whitespace changes)
-rw-r--r-- | noncore/net/wellenreiter/README | 27 |
1 files changed, 20 insertions, 7 deletions
diff --git a/noncore/net/wellenreiter/README b/noncore/net/wellenreiter/README index c04d30c..af2e611 100644 --- a/noncore/net/wellenreiter/README +++ b/noncore/net/wellenreiter/README @@ -1,26 +1,23 @@ /*************************************************************************/ /* W e l l e n r e i t e r I I */ /* =============================== */ /* */ -/* Version: Opie-ALPHA */ + /* Version: Opie-ALPHA-January */ /*************************************************************************/ -------------------------------------------------- -Release Notes for Opie-ALPHA Version December 2002 +Release Notes for Opie-ALPHA Version January 2002 -------------------------------------------------- ===================== = Supported Devices = ===================== * low-level orinoco_cs-based (including prism2 and spectrum_cs) -* Supported Interfaces: wlan0 (yes, I know this is hardcoded and - lame, but we're in a hurry and this can be configured soon...) - ===================== = Build = ===================== To compile Wellenreiter within the Opie build environment, add the following directories to $OPIEDIR/Makefile, e.g. to 'NONAPPS=' @@ -29,30 +26,46 @@ noncore/net/wellenreiter/libwellenreiter \ noncore/net/wellenreiter/daemon \ noncore/net/wellenreiter/contrib/orinoco_hopper \ noncore/net/wellenreiter/gui ./configure and rebuild. Note that you need libpcap in your toolchain. +To compile Wellenreiter within the OZ build environment, add the +following lines to $OPIEDIR/packages +CONFIG_WELLENREITER noncore/net/wellenreiter/libwellenreiter libwellenreiter.pro +CONFIG_WELLENREITER noncore/net/wellenreiter/daemon daemon.pro +CONFIG_WELLENREITER noncore/net/wellenreiter/gui gui.pro +CONFIG_WELLENREITER noncore/net/wellenreiter/contrib/orinoco_hopper orinoco_hopper.pro + +make -f Makefile.test clean-configs +cd <BUILDROOT> +make SUBDIRS=packages/opie package + ===================== = Install = ===================== Alternatively, you can use our precompiled ipk. Get it from -http://opie.net.wox.org/elan/current. You will also need libpcap. +http://opie.net.wox.org/wellenreiter/current/. This also includes a recent libpcap. ===================== = Run = ===================== +There are two possible modes: <Manual> and <Automatic>. I suggest, you +start with the <Automatic> Mode. This works just using the "Start" +and "Stop" Pushbuttons in the Wellenreiter GUI. If this doesn't work, +then use the following strategy: + 1. Place card in monitor mode. This is device dependent. Caution: Don't do this while you're logged in via ssh or otherwise using the wireless interface - your connection will freeze: The card can't be used normally when sniffing! - For most orinoco-based cards this can be done using + For most orinoco-based cards this can be done using either 'iwpriv <interface> 2' or 'iwpriv <interface> 2 1'. You can check if this works, by calling 'ifconfig <interface>'. If you see 'Protocol: UNSPEC' and an unusual long MAC-Address, then your card has been successfully set to the monitor mode. |